Normally Open Contact Symbol

There is a common electrical connection between a contact of each pair that results in only three connection terminals.

Normally open contact symbol.

Usually at about 75 speed of motor. On off switch spst spst single pole. Normally open is a contact that does not flow current in its normal state. Relays and contactors have two types of contacts each suited for different applications.

Energizing it and switching it on will close the contact causing it to allow current flow. These terminals are usually labelled as normally open common and normally closed no c nc. There is also a generic symbology for any switch contact using a pair of vertical lines to represent the contact points in a switch. Normally open contacts are designated by the lines not touching while normally closed contacts are designated with a diagonal line bridging between the two lines.

Form c contacts change over or transfer contacts are composed of a normally closed contact pair and a normally open contact pair that are operated by the same device. In other words when voltage is applied to the relay contactor terminals this contact closes. Next we have the normally open timed open noto contact. If the contact is normally open it would not allow any current to pass through it and hence there will be an open circuit at this contact.

The following is a timing diagram of this relay contact s operation. Also now is a good time to remind you that this is article is talking about the electrical normally open and normally closed symbols which while may look the same as the. Some of the most common and widely used symbols are given below 1. Normally closed nc contacts allow current through when the relay or contactor is not energized.

Like the notc contact this type of contact is normally open when the coil is unpowered de energized and closed by the application of power to the relay coil. Normally open no contacts allow current when the relay or contactor is energized. In a schematic diagram the switch symbol appears to be a toggle switch with a flag hanging below. Normally open switch contacts are sometimes referred to in the electrical industry as form a contacts.

This is the switch used to operate a doorbell. If we had used a normally closed pushbutton switch instead the behavior would be exactly opposite. Note the following symbols. The given symbol indicates a normally open contact.

This type of push switch is normally closed on it is open off only when the button is pressed.